Ryobi RPW190BL-G, Operating Instructions Manual

Page: 15 / 32

13
GETTING STARTED GETTING STARTED GETTING STARTED GETTING STARTED
11
1
2
1
2
4 3
10
2
1
1
2
3
4
8
5 6 1 2
9
30 sec
1
2
7
Wear full eye and ear protection, protective gloves,
substantial footwear, and long trousers at all times while
operating the product. Do not operate the product when
barefoot or wearing open sandals.
Push and hold the push-pin buttons on the rear side of the
frame as you slide the handle over the frame. Push down
or pull up the the handle until the buttons snap through,
securing the handle in place.
Pull back the quick-connect collar. Push the desired nozzle
into the quick-connect collar until it clicks into place and is
secured properly.
Connect the threaded end of the spray wand to the
connector end of the handle. Turn the wand clockwise to
secure the wand. Connect the collar of the high pressure
hose to the threaded inlet coupler of the trigger handle.
Turn the hose collar clockwise to secure the hose. Avoid
cross-threading the collar and outlet coupler to avoid leaks
from the trigger handle.
Turn on water supply. Completely uncoil and straighten the high pressure hose to
prevent kinks. Connect the hose collar to the water outlet
port and turn the collar clockwise to secure the hose. Avoid
cross-threading the collar and outlet coupler to avoid leaks
from the hose.
Completely uncoil and straighten the garden hose to
prevent kinks. Connect the garden hose to the water inlet
port. Connect the other end of the garden hose to the
garden tap.
Push the trigger lock out down until it clicks into position.
Squeeze the trigger to relieve air pressure and hold for
30 secs to run water and clean any debris from the hose.
Connect the product to a power outlet. Press the on/off switch to turn on the product. Squeeze and hold the trigger to operate the product.