TROUBLESHOOTING
Problem
Possible cause
Solution
Line will not advance when
1. Line is welded to itself.
1. Lubricate with a silicone spray.
tap bump button
2. Not enough line on spool.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3.
Line is worn too short.
3. Pull lines while alternately pressing down on and
releasing bump button.
4.
Line is tangled on spool.
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this manual).
Bump head is hard to turn
Grass wrapped or built up
Clean affected parts of the machine.
around
head.
Grass wraps around the
Cutting tall grass
Cut tall grass from the top down.
attachment shaft and the
at ground level.
trimmer head assembly
DISPOSAL
Waste electrical products should not be disposed of together with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for recycling advice.
15
English
GB
F
E
I
P
NL
S
DK
N
FIN
GR
TR
EST
LT
LV
RLT3725CH-A_15 .indd 15
RLT3725CH-A_15 .indd 15
5/14/08 4:07:27 PM
5/14/08 4:07:27 PM
Summary of Contents for RLT3725-A
