6
ENGLISH (Original Instructions)
Figure 17
48. String line
49. Slot
50. Hole
Figure 18
51. Idle speed screw
Figure 19
20. Air box latch
Figure 20
52. Filter screen
53. Air box cover
Figure 21
51. Idle speed screw
53. Air box cover
ASSEMBLY
UNPACKING
This product requires assembly.
■
Carefully remove the tool and any accessories from the box.
Make sure that all items listed in the packing list are included.
■
Inspect the tool carefully to make sure no breakage or damage
occurred during shipping.
■
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
■
If any parts are damaged or missing do not operate this product
until the parts are replaced.
PACKING LIST
■
Trimmer assembly
■
Reel Easy™ string head
■
Pro Cut II
TM
string head
■
Shoulder strap
■
12 volt battery
■
Charger
■
Front handle assembly
■
Grass deflector assembly
■
Hanger cap
■
Combination wrench
■
Operator’s manual
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug and remove battery pack when
assembling parts.
INSTALLING THE POWER HEAD SHAFT TO THE
ATTACHMENT
See Figure 2.
WARNING:
Never install, remove, or adjust any attachment while
power head is running. Failure to stop and disable the
engine can cause serious personal injury.
The attachment connects to the power head shaft by means of a
coupler device.
■
Loosen the Wing Screw on the coupler of the power head shaft
and remove the end cap from the attachment.
■
Push in the button located on the attachment shaft. Align the
button with the guide recess on the power head coupler and
slide the two shafts together. Rotate the attachment shaft until
the button locks into the positioning hole.
NOTE:
If the button does not release completely in the
positioning hole, the shafts are not locked into place. Slightly
rotate from side to side until the button is locked into place.
■
Tighten the Wing Screw securely.
ASSEMBLY
WARNING:
Be certain the Wing Screw is fully tightened before
operating equipment; check it periodically for tightness
during use to avoid serious personal injury.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
For removing or changing the attachment:
■
Loosen the Wing Screw.
■
Push in the button and twist the shafts to remove and separate
ends.
ATTACHING THE HANGER CAP
See Figure 3.
There are two ways to hang your attachment for storage.
■
To use the hanger cap, push in the button and place the hanger
cap over end of the lower end attachment shaft. Slightly rotate
the cap from side to side until the button locks into place.
■
The secondary hole in the attachment shaft can be used for
hanging purposes.
ATTACHING THE FRONT HANDLE
See Figure 4.
■
Remove the bolts (30) and bracket (31) from the front handle
(32).
■
Install the front handle (32) onto the top side of the power head
shaft (25).