4
English (Original Instructions)
37. 2cm Protruding line
FIGURE 9
20. Foam air
fi
lter
21. Air
fi
lter cover
22. Cover securing knob
FIGURE 10
23. Spark plug boot
24. Spark plug
FIGURE 11
25. Spark arrestor
ASSEMBLY
ATTACHING THE POWER HEAD TO THE TRIMMER
ATTACHMENT (FIG. 1)
■
Follow these steps to connect the attachment to the
upper shaft (item 1).
■
Loosen the knob (item 2) by turning it counter
clockwise.
■
Align the button (item 3) on the attachment shaft with
the guide recess (item 4) on the upper shaft.
■
Slide the attachment shaft into the upper shaft until the
attachment shaft clicks into place.
■
Tighten the knob securely by turning it clockwise.
Removing the attachment from the upper shaft.
Follow
these steps to remove the attachment from the upper
shaft.
■
Loosen the knob by turning it counterclockwise.
■
Push the button while pulling out the attachment.
ATTACHING THE FRONT HANDLE (FIG. 2)
■
Remove the two securing bolts (item 9) from the front
handle (item 5).
■
Position the front handle (item 5) onto the upper shaft
(item 1).
NOTE
: The lever protruding from the front handle
should point to the left side of the trimmer (as shown
on Fig 1 & 2).
■
Position the bracket (item 10) underneath the front
handle and secure in place by screwing the securing
bolts (item 9) through the base of the front handle into
to the bracket (item 10).
SAFETY GUARD (FIG. 3)
■
Remove wing nut (item 14), flat washer (item 12), lock
washer (item 13) and bolt (item 11) from the Owner's
Kit.
■
Place safety guard (item 6) over shaft and bracket.
■
Install bolt through the slots in the tabs on safety guard
- Equivalent
107.5 dB(A)
Uncertainty 2.5
dB(A)
DESCRIPTION
FIGURE 1
1. Upper shaft
2. Knob
3. Button
4. Guide recess
5. Front handle
6. Safety guard
7. Trimmer line
8. ReelEasy™ trimmer head
FIGURE 2
5. Front handle
9. Securing bolts
10. Bracket
FIGURE 3
11. Securing bolt
12. Flat washer
13. Lock washer
14. Wing nut
FIGURE 4
15. On/Off switch
16. Throttle lock out button
17. Throttle trigger
18. Primer bulb
19. Starter grip
FIGURE 5
38. Choke lever
FIGURE 8
26. Bump head cover
27. Bump knob
28. Line spool
29. Bump head spring
30. Bump head securing bolt
31. Cutting head housing
FIGURE 8a
32. Drive shaft
33. Pro Cut II™ String head
34. Spool retainer
FIGURE 8b
35. Line exit holes
36. Line loading holes