17
English (Original instructions)
Hand thread the new spark plug into the cylinder,
turning it clockwise.
Tighten with a socket. Torque to 24,40 Nm (216 lb.in.)
minimum, 29,82 Nm (264 lb.in.) maximum. Do not
over-tighten.
TRANSPORTATION AND STORAGE
Stop the engine and allow the product to cool down
before storing or transporting.
Clean all foreign materials from the product.
Drain all fuel from the tank into a container approved
for petrol. Remember to properly replace and tighten
the fuel cap.
Run the engine until it stops, this will remove all fuel
that could become stale and leave varnish and gum
in the fuel system.
If applicable, drain all lubricant from the engine into
a container approved for lubricant. Remember to
properly replace the lubricant cap.
Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children. Keep away from
corrosive agents, such as garden chemicals and de-
icing salts.
Do not store outdoors.
When transporting the product in a vehicle, secure
it against movement or falling to prevent injury to
persons or damage to the product.
Never transport the product while the engine is
running.
Abide by all government and local regulations for the
safe storage and handling of petrol.
Short term (less than 1 month)
Stop the engine and allow the product to cool down
before storing or transporting.
Clean all foreign materials from the product.
Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Do not store outdoors.
SYMBOLS
Some of the following symbols may be used on this
tool. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate
the tool better and safer.
Read this safety and operating instructions
in this manual and keep it in a safe place
for future reference.
Beware of thrown or
ying objects. Keep
all bystanders at least 15 m away.
Wear eye protection.
Wear ear protection.
Do not run product without the tubes in
place.
Risk of long hair being drawn into the air
inlet.
Risk of loose clothing being drawn into the
air intake.
To reduce the risk of injury or damage,
avoid contact with any hot surface.
Warning! Hot surface.
Dangerous feed ori
ce and rotating fans.
Keep hands and feet out of the openings
while the product is running.
Use unleaded petrol intended for motor
vehicle with an octane rating of 91
([R+M]/2) or higher.
Use 2-stroke oil for air-cooled engines.
Mix the fuel mix thoroughly before
refuelling.
Full choke
Half choke
Run position
Unlock the cruise control lever.
Pull the starter grip until the engine
attempts to start. Do not pull the starter
grip more than 8 times.
6
Pull the starter grip until the engine
attempts to start. Do not pull the starter
grip more than 6 times.
Press the primer bulb 10 times.
