SERVICE
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly
and understand completely the operator's
manual. Save this operator's manual and review
frequently for continuing safe operation and
instructing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage. Before
beginning power tool operation, always wear
safety goggles or safety glasses with side shields
and a full face shield when needed. Always use
eye protection.
SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
SPECIFICATIONS
RBV2400VPG
Voltage
220-240V~ 50Hz
Power
2400W
Air velocity
185~237km/h
Air volume
10~16m
3
/min
Mulching ratio
10:1
Dust bag capacity
45L
Vibration level
< 25m/s
2
DESCRIPTION
1. Shoulder strap
2. Rear handle
3. On/Off Switch
4. Speed control dial
5. Front handle
6. Motor housing
7. Nozzle
8. Guide wheels
9. Patio head
10. Dust bag
11. Blower / vac mode selection lever
12. Power cable & plug
13. Live tool indicator
14. Dust bag holder
ASSEMBLY
ATTACHING THE NOZZLE (Fig.2)
CAUTION
Do not operate the product without the two
sections of the nozzle (7) assembled.
■
The nozzle (7) comes in two sections. Assemble the
sections by slotting them together as shown in Fig.2
Ensure the sections have clicked into place and are
aligned properly.
Fasten the sections together at the top and at the
bottom, with screws provided.
■
Slide the assembled nozzle into the motor housing
(6). With the latches at the top and at the bottom, lock
the nozzle in place.
ATTACHING AND REMOVING THE DUST BAG
(10) (Fig.3 & 4)
CAUTION
Do not use the Blower/Vac in the vacuum mode
without the dust bag (10) in place.
■
Latch the front of the dust bag holder (14) to the front
of the dust exhaust and then lift the dust bag handle
side until the dust bag holder secures to the housing.
See Fig.3
■
Hang the strap at the front of the dust bag to the
bottom of the nozzle. See Fig.4
■
When removing the dust bag, detach the strap at
the front of the dust bag from the nozzle first, then
press the release on the dust bag holder and gently
dislodge the dust bag off the motor housing.
ASSEMBLY
SHOULDER STRAP(1) (Fig.3)
■
Attach the metal fixture of the shoulder strap to the
hole just in front of the ON/OFF switch.
■
Adjust the shoulder strap to a length comfortable for
your use.
OPERATION
■
Plug the Blower/Vac into the mains supply. The
LiveTool indicator (13) will light up.
Note:
To reduce the risk of injury, safety switches are
installed in the nozzle. The Blower/Vac cannot be
turned on unless the nozzle is attached.
5
English