Ryobi RBL26G, Original Instructions Manual, Page: 17 / 32

17
GETTING STARTED GETTING STARTED GETTING STARTED
6x
VI
10 11
1
2
3
4
12 13 14
10 10
5
6
7
1
2
3
4
3
1.
Align raised tabs on upper blower tube with the slots on blower housing outlet.
2.
Attach and tighten securely by turning
clockwise until it clicks into place. 3. Attach desired nozzle to upper blower tube. 4. Tighten securely by turning clockwise
until it clicks into place.
1.
Loosen the fuel cap slowly by turning it counterclockwise.
2. Remove the fuel cap. 3. Pour the fuel mixture carefully
into the tank. Replace and tighten the fuel cap.
Press the primer bulb 10 times or until fuel appears. Pull the cruise control lever back, towards the user. Set the choke lever to “FULL” choke position.
Pull the starter grip sharply until the engine starts. Do not
pull the starter grip more than 6 times.
When engine starts, wait and let it warm up for 10 seconds. Set the choke lever to “RUN” position. Hold the blower with the upper handle in your right hand.
Hold the blower as shown so the air stream can work close
to the ground.
To stop the engine, toggle the switch to the “STOP”
position.