3
–
Arsenic, beryllium, chromates, cobalt and nickel in
total 0.2 % of mass fraction;
–
Beryllium, chromates, cobalt, cadmium separately
0.1 % of mass fraction;
–
Metallic compounds shall be calculated as the
metal element and chromates as CrO3;
–
Free crystalline silicic acid (SiO2): 2 % of mass
fraction.
SpecIfIcATIONS
Air sand blasting gun
Model
RA-SBG-B
Average air consumption
330 L/min @
6.3 bar (90 psi)
Maximum working pressure
6.3 bar (90 psi)
Weight
0.68 kg
Air inlet size
6.35 mm (1/4” BSP)
Air hose ID
9.52 mm (3/8”)
Hopper capacity
0.62 L
Abrasive media size
120~180 Micron
(120~80 Mesh)
Abrasive media type
Glass fibre sand
Air quality
Oil-free compressed
air
A-weighted sound pressure
level
LpA: 86 dB(A),
KpA=3dB
Sound power level
LwA: 97 dB(A),
KwA=3dB
Vibration value
ah: 0.4 m/s
2
Uncertainty
K=1.5 m/s
2
Noise emission values are in accordance with EN 1265,
and this air sand blasting gun noise level is tested at no
load.
Vibration emission values are in accordance with EN ISO
20643.
wARNING
The vibration level specified in these instructions has
been measured in accordance with a standardised
measuring procedure specified in EN ISO 20643 and
can be used to make equipment comparisons. The
specified vibration emission value can also be used to
make an initial exposure estimate.
The vibration level varies in accordance with the use
of the compressed air tool and may be higher than
the value specified in these instructions in some
cases. It is easy to underestimate the vibration load if
the compressed air tool is used regularly in a certain
manner.
INTeNDeD USe
The air sand blasting gun is intended to be used only by
adults who have read and understood the instructions
and warnings in this manual, and can be considered
responsible for their actions.
The product is intended for removing metal surface
contaminants, stains, rust, paint, oil, roughening/matting
a surface, etc,. using abrasive materials.
Do not use the product for any other purpose.
ReSIDUAL RISkS
Even if you are operating this product in accordance
with all the safety requirements, potential risks of injury
and damage remain. The following dangers can arise in
connection with the structure and design of this product:
1. Dust and fumes generated when using the product
can cause health defects.
–
Only work in sufficiently ventilated area.
–
Always wear a safety mask when using the product
and keep other people far away from work area.
2. Danger of injury and property damage caused by high
speed sanding abrasive.
–
Wear appropriate personal protective equipment.
–
Prior to operation, protect other people and
property in the work area from high speed sanding
abrasive by providing barriers or shields.
ASSeMBLy
AIR SUppLy SeT Up
See figure 2.
■
Make sure the regulator is in the "off" position.
■
Connect the product to a quick coupler. Wrap the
thread with thread seal tape.
■
Attach the air hose to the compressor's air outlet. Then
connect the other end to the quick coupler attached to
the product.
