Ryobi R18SS4, Original Instructions Manual

Page: 5 / 20

ADDITIONAL BATTERY SAFETY WARNINGS
WARNING
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your
tool, battery pack or charger in fluid or allow a fluid to
flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
■ Ambient temperature range for battery during use is
between 0°C and 40°C.
■ Ambient temperature range for battery storage is
between 0°C and 20°C.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps
or tape. Do not transport batteries that are cracked or
leaking. Check with the forwarding company for further
advice.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
■ entrapment/contact with the sanding sheet
Additional caution must be exercised to prevent
operator’s fingers and hands from coming into contact
with the sanding sheet
■ contact with or inhalation of dust
While using the product, considerable dust and fine
particles will be produced. Use the dust collection
device during use. Wear respiratory protection masks
containing filters appropriate to the materials being
worked. Ensure adequate workplace ventilation. Do not
eat, drink, or smoke in the work area.
■ risk of explosion
Accumulated fine dust may ignite and cause fire. Keep
the work area clean and free from dust. Dust collection
and vacuum extraction systems should be regularly and
thoroughly cleaned. When sanding metal, hot sparks
may be produced.
■ noise and vibration
Wear ear protection when operating the product. Do not
operate the product for extended periods of time.
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud’s Syndrome
in certain individuals. Symptoms may include tingling,
numbness and blanching of the fingers, usually apparent
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking, and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
■ Keep your body warm in cold weather. When operating
the product wear gloves to keep the hands and wrists
warm. It is reported that cold weather is a major factor
contributing to Raynaud’s Syndrome.
■ After each period of operation, exercise to increase
blood circulation.
■ Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
KNOW YOUR PRODUCT
See page 7.
1. Switch on
2. Switch off
3. Battery port
4. Dust vacuum adapter
5. Paper clamp
6. Cushion
7. Lever
8. Dust bag
9. Sandpaper (80 grit)
10. Sandpaper (120 grit)
11. Sandpaper (220 grit)
12. Insulated grasping surface
MAINTENANCE
WARNING
Empty bag frequently and before storage to avoid
possible fire hazard due to self-ignition of the dust.
WARNING
The product should never be connected to a power
supply when you are assembling parts, cleaning,
performing maintenance, or when the product is not in
use. Disconnecting the product will prevent accidental
starting that could cause serious injury.
3