Ryobi R18IDBL, Original Instructions Manual

Page: 5 / 12

3
Ŷ After each period of operation, exercise to increase
blood circulation.
Ŷ Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 5.
1. Coupler
2. Tri-beam LED
3. Direction of rotation selector
4. Variable-speed switch trigger
5. Bit storage
6. Single bit
7. Battery port
8. Mode selection button
9. Low speed
10. Medium speed
11. High speed
12. DeckDrive™ mode
MODE SELECTION
The product features electronic speed control. Press the
mode selection button to change the performance of the
product to suit your application.
Changing the speed on an impact driver also effects the
torque. For small screws, use speed 1. For a better control
with mid-sized screws, use speed 2. For maximum speed
and power when driving large screws, use speed 3.
'HFN'ULYHŒ LV D PRGH SURJUDPPHG ZLWK D SUR¿OH WKDW
suits driving decking screws. It has a soft start-up to catch
the screw thread, the impact driver then accelerates up to
full speed before slowing down when the screw is almost
ÀXVK WR DOORZ \RX WR VHW WKH VFUHZ KHDG FRUUHFWO\ 7KLV
SUR¿OHLVRSWLPLVHGIRUGULYLQJVFUHZVDURXQG[PP
into Merbau decking and pressure treated pine joists with
a pilot hole. Results may vary depending on screw length
and materials. It is recommended to practice the deck drive
mode on a separate piece of timber.
MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
Ŷ When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Ŷ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt and carbon dust.
Ŷ Do not, at any time, let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
Ŷ Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
Ŷ For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
VXI¿FLHQWDPRXQWRIKLJKJUDGHOXEULFDQWIRUWKHOLIHVSDQRI
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Please read the instructions carefully
before starting the machine.
No-load speed
V Volts
Direct current
min
-1
Revolutions or reciprocations per minute