ASSEMBLY
MUFFLER GUARD ASSEMBLY (FIG. 4)
1. Remove muffler guard (17) and two screws (47) from the
owner's kit.
2. Attach the muffler guard to the rear housing (18).
NOTE:
Make sure the bent end of the muffler guard (20)
fits securely into the opening of the rear housing (21).
3. Install two screws.
4. Tighten screws securely.
FRONT HANDLE (FIG. 3)
1. Remove the front handle (2), bolt, and wing nut from the
Owner's Kit.
2. Install the front handle onto the top side of the drive
shaft housing and move it to a comfortable position.
3. Place the bolt through the front handle as shown, then
install the wing nut.
4. Tighten wing nut securely.
NOTE:
Do not attempt to remove or modify the spacer.
This spacer limits the upper position of the handle grip.
SAFETY GUARD (FIG. 2)
1. Remove wing nut (14), flat washer (16), lock washer (15),
and bolt (12) from the Owner's Kit.
2. Place safety guard (5) over shaft (3) and bracket (13).
3. Install bolt through the slots in the tabs on safety guard
and bracket on driveshaft housing.
4. Install flat washer, lock washer and wing nut.
5. Tighten Securely.
OPERATION
FUEL AND REFUELING
HANDLING THE FUEL SAFELY
Always handle petrol with care, it is highly flammable.
Always refuel outdoors where there are no sparks and
flames. Do not inhale petrol vapors.
Do not let petrol or oil come in contact with your skin.
Keep petrol and oil away from the eyes. If petrol or
oil comes in contact with the eyes, wash them immedi-
ately with clean water. If irritation is still present, see a
doctor immediately.
Clean up spilled fuel immediately.
NOTE
: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
T
ighten the knob securely
.
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
REMOVING THE AT TACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
Loosen the knob.
Push in the button and twist the shafts to remove and
separate ends.
Read the operation manual and follow all
warnings and safety instructions.
Wear eye protection and ear protection.
Keep all by standers, especially children
and pets,, at least 15m from the operating
area.
-
4
-