11
OPERATION
CHARGING A HOT BATTERY PACK
When using the product continuously, the batteries in the
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Authorized
Service Center for checking or replacing.
NOTE:
This situation only occurs when continuous use of
the product causes the batteries to become hot. It does not
occur under normal circumstances. Refer to
CHARGING A
COOL BATTERY PACK
for normal recharging of batteries.
If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Authorized Service Center for
electrical check.
TO INSTALL BATTERY PACK
See Figure 3.
Place the battery pack in the hand vac. Align the raised
rib on the battery pack with groove in hand vac’s battery
port.
Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
hand vac before beginning operation.
TO REMOVE BATTERY PACK
See Figure 3.
Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
hand vac.
STARTING/STOPPING THE VACUUM
See Figure 4.
To start the vacuum:
slide the switch toward the front
of the vacuum.
To stop the vacuum:
slide the switch toward the back
of the vacuum.
Fig. 2
Fig. 3
P110
CHARGER
P100 BATTERY
PACK
GREEN
LED
YELLOW LED
RED LED
BATTERY PACK
LATCHES
Fig. 4
ON/OFF
SWITCH
TO TURN
ON
TO TURN
OFF
