11 — English
OPERATION
The driver mechanism can usually be returned to its operating
position by depressing the workpiece contact against a scrap
piece of wood and squeezing the trigger.
If this does not automatically return the driver mechanism
into the tool, the tool may be jammed.
If a nail or fastener becomes jammed in the tool, remove
the battery pack and keep the tool pointed away from you
while clearing the jam.
Remove battery pack from the tool.
Remove fasteners from the tool.
Pull up on the latch and open the jam release.
Insert a flat blade screwdriver into the tip of the driving
mechanism and push the driver mechanism back, freeing
the nail jam.
Remove the bent nail.
Close the jam release and latch.
Reinstall nails.
Reinstall the battery pack, reactivate tool.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Work-contacting element does not
depress fully - tool does not operate.
Low nails
Work-contacting element is jammed
Replenish nails
Remove battery and clear debris
Tool operates properly, but fasteners do
not drive fully.
Air pressure is too low
Depth of drive isn’t deep enough
Nail is too long for wood hardness
Increase air pressure
Adjust depth of drive
Use nail length that is appropriate for
wood
Tool operates properly, but fasteners are
driven too deep.
Air pressure is too high
Depth of drive is too deep
Decrease air pressure
Adjust depth of drive
Tool jams frequently.
Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Tool stops and LED flashes rapidly.
Battery is low or has no charge
Trigger released too early
Recharge battery
Remove battery and reinstall
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use.
Tool has malfunctioned
Take tool to nearest authorized repair
center
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
ILLUSTRATIONS START ON PAGE 13.
THIS PRODUCT HAS A 90-DAY SATISFACTION GUARANTEE
POLICY, AS WELL AS A THREE-YEAR LIMITED WARRANTY. FOR
WARRANTY AND POLICY DETAILS, PLEASE GO TO
WWW.RYOBITOOLS.COM OR CALL (TOLL FREE) 1-800-525-2579.
