Ryobi ONE+ R18R-0 Original Instructions Manual Download Page 5

Page: 5 / 156

English

2. Loosen the screw in the battery door. Remove the door

and set aside.

3. Install two new AAA batteries according to polarity

indicators inside the battery compartment.

NOTE:

Do not mix old and new batteries. Do not mix

alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.

4. Replace the battery cover and tighten screw to secure.

INSTALLING/REMOVING BATTERY PACK

See page 6.

To install battery pack:

1. Place the battery pack in the product, aligning the rib

on the battery pack with the groove in the battery port.

2. Make sure the latches on the battery pack snap into

place and the battery pack is secured to the product
before beginning operation.

3. Depress the latches to remove the battery pack.

NOTE:

Always remove battery pack from radio when not

in use.

FOLD-DOWN FLEXIBLE ANTENNA

To decrease interference or electrical noise, extend the
antenna or move the product to a higher elevation. The
antenna folds down and out of the way when not in use.

CONTROL PANEL

Frequency modulation mode

Amplitude modulation mode

Auxiliary mode, allows another audio
storage device or player to connect to
product
Allows wireless communication
between the product and another
Bluetooth-enabled device

Press to change clock settings, mode
display

Press to store/ preset FM/AM
frequencies in memory

Press to turn on and off the product

To select mode: FM, AM or AUX,
disconnect the product from the paired
device

To adjust the volume or to set the time
when in clock mode

For automatic scan of available FM or
AM frequencies

LCD DISPLAY

When a battery pack is installed and the product is in the
ON position, the LCD display will show the time, frequency,
mode, and settings. When the battery pack is removed and
AAA batteries are installed, the LCD display will display the
time only.

NOTE:

The illustrations of the LCD display shown in the

manual are only examples of the frequencies you may see
on your radio and are not the exact frequencies that you
may choose to listen to.

MENU NAVIGATION BUTTONS

Use the menu navigation buttons to turn the product on
and off, control the volume, change frequencies, toggle
between modes and set the time.

TURNING THE PRODUCT ON AND OFF

See page 8.

■

Press

to turn the product on and off.

NOTE:

When the product is on and a battery pack is

installed, the battery symbol will be shown in the LCD
display. If the battery charge is low, a flashing low battery
indicator will be displayed.

MODE SELECTION

See page 8.

■

Press

to cycle through available modes.

There are four modes to choose from:

■

FM mode

■

AM mode

■

AUX mode

■

BLUETOOTH

mode

NOTE:

When turned on, the product will return to the last

mode that was used if the battery was not disconnected.
In the event power is lost to the product, the display will
default to FM mode.

ADJUSTING THE VOLUME

See page 8.

When the product is turned on, the product will return to the
last volume setting used.

■

To increase the volume, press .

■

To decrease the volume, press .

FM/AM TUNING

See page 9.

Use and to tune to the desired radio frequency. The
selected frequency is displayed on the LCD.

To tune frequency manually:

Briefly push either   or   (not press and hold) to tune one
frequency step at a time.
1.  Press and release   to tune to a lower frequency.
2.  Press and release   to tune to a higher frequency.