6
WORKING WITH TRIPOD (available separately)
This laser distance measure has been designed to be a
low-maintenance tool. However, in order to maintain its
performance, you must always follow these simple directions.
1. Always
handle the tool with care. Treat it as an optical device,
such as a camera or binoculars.
2. Avoid
exposing the tool to shock, continuous vibration or
extreme hot or cold temperature.
3. Always
store the tool indoors. When not in use,
ALWAYS
store
the tool in its protective case.
4. Always
Keep the tool free of dust and liquids. Use only a clean,
soft cloth for cleaning. If necessary, slightly moisten the cloths
with pure alcohol or a little water.
5. Do not
touch the lens with your fingers.
6. Check the batteries regularly to avoid deterioration.
ALWAYS
remove the batteries from the tool, if it is not going to be used
for an extended period of time.
7. Replace the batteries when the battery icon is continuously
empty displayed on the LCD.
8. Do not
disassemble the laser measuring tool; this will expose
the user to hazardous radiation exposure.
9. Do not
attempt to change any part of the laser lens.
The use of a tripod is particularly helpful for greater distances. The
measuring tool can be mounted on a commercially available tripod
using the 1/4” thread on the bottom side of the mounting base.
1. Mount the mounting base to the tripod.
2. Attach the measuring tool to the mounting base.
Point operation: Place the wall mount base via ¼’’ tripod mounting
hole (14) onto the 1/4” male thread of the tripod and screw the
locking screw of the tripod tight. Align the tripod roughly.
When working without tripod, place the wall mount base on a
surface that is as horizontal as possible. Position the measuring
tool with the aluminium base facing down on the wall mount base,
and stick it with the magnet to the reference surface for laser
pointer (12).
Horizontally align the upper part of the wall mount base with
adjusting screw (13) and spirit level for horizontal alignment of the
measuring tool. Turn the upper part of the wall mount base by 90`
and repeat the alignment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WORKING ADVICE
For marking, always use only the centre of the laser point or the
laser line. The size of the laser point as well as the width of the
laser line may vary on different working distance.
MAINTENANCE
Summary of Contents for LSL-100
