10
TROUBLESHOOTING
Warning!
Warranty:
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.
The motor does not run
Shredder fails to operate
The material to be shredded is
Not Pull in
The following chart lists problem symptoms, possible causes and corrective action, if your shredder does not operate properly.
If these do not identify and correct the problem, contact your service agent.
The manufacturer provides warranty in accordance with the legislation of the customer’s own country of residence, starting from
the date on which the appliance is sold to the end user. The warranty only covers defects in material or workmanship.
The repairs under warranty may only be carried out by an authorized service center. When making a claim under the warranty,
the original bill of purchase (with purchase date) must be submitted.
The warranty will not apply in cases of:
1. Normal wear and tear
2. Incorrect use, e.g. overloading of the appliance, use of non-approved accessories
3. Use of force, damage caused by external influences
4. Damage caused by non-observance of the user manual, e.g. connection to an unsuitable mains supply or non-compliance
with the installation instructions
5. Partially or completely dismantled appliances
The overload protection has
responded.
Cut chamber locking knob not
fully in position.
Press the Reset button, and
then press the “I” button.
Locking knob of cut chamber
not fitted correctly.
Fit the locking knob correctly.
Retighten the locking knob.
Mains socket faulty.
Use another socket.
Extension cable damaged.
Replace if damaged.
Jammed material in the machine.
Clear jammed material, if necessary,
use the Allen key to rotate the motor
spindle.
Summary of Contents for GGS-3000
Page 2: ...1 Allen key 4 11 6 8 1 12 2 5 9 10 7 3...
Page 6: ...5 15 14 16 17 Fixed pin 40mm 40mm...
Page 12: ......