Page 12
MAINTENANCE
WARNING:
To prevent accidental starting that could cause possible
serious personal injury, turn off and unplug the saw before
maintaining or lubricating your scroll saw.
WARNING:
Failure to unplug your saw could result in accidental
starting causing serious injury.
TROUBLESHOOTING
WARNING:
For your own safety, turn switch OFF and remove plug from power outlet before adjusting or aligning your scroll saw.
PROBLEM
Motor will not run.
Blades breaking.
Vibration(there is always
some vibration when the
saw is running).
Blade runout (blade not
properly aligned with arm
motion).
CAUSE
1. Problem with ON-OFF switch,
power cord, or outlet.
2. Motor defective.
1. Too much tension.
2. Feeding too quickly.
3. Wrong blade.
4. Blade twisting in wood.
1. Improper mounting of saw.
2. Mounting surface.
3. Loose table or table resting
against motor.
4. Loose motor mounting.
1. Blade holders out of line.
SOLUTION
1. Have worn parts replaced before using Scroll Saw
again. Have the proper outlet installed by a qualified
electrician.
2. Do not attempt any repair. Have repaired by a qualified
service technician.
1. Adjust tension.
2. Reduce feed rate.
3. Narrow blades for cutting thin wood or tight corners
and turns, wide blades for thicker wood or wide turns.
4. Reduce side pressure on blade, check blade tension.
1. Check mounting.
2. Check mounting in manual.
3. Tighten table lock knob.
4. Tighten mounting screws.
1. Realign blade.
