6
removed from both pulleys.
5. Install the new belt over the large pulley. As you turn
the belt, push and work it onto the small pulley until it
is in place.
6. Replace the belt cover.
7. Install belt cover screws and tighten securely, but do
not overtighten.
NOTE:
Do not overtighten the screws.
After use, check the tool to make sure that it is in good
condition. It is recommended that you take this tool to a
RYOBI Authorised Service Centre for a thorough cleaning
and lubrication at least once a year.
Do not make any adjustments while the motor is in motion.
Always disconnect the power cord from the power supply
before changing removable or consumable parts (blade),
before lubricating or working on the unit.
If the supply cord is damaged, it shall be replaced by
the manufacturer or its service centre or similar qualifi ed
person in order to avoid a hazard.
WARNING
To ensure safety and reliability, all repairs should be
performed by an authorised service centre or other
qualifi ed service organisation.
