2
English
GB
FR
DE
ES
IT
NL
PT
DK
SE
FI
NO
RU
PL
CZ
HU
RO
LV
LT
EE
HR
SI
SK
GR
TR
OPERATION
DRILLING IN WOOD
To prevent ugly splits around the drill hole on the reverse
side of the workpiece, put a piece of scrap timber under
the work piece.
DRILLING IN METAL
Metals such as steel brass, aluminum sheets, stainless
steel, and pipe may also be drilled. Mark the point to be
drilled with a nail or punch.
Do not use impact drilling mode on these materials.
DRILLING IN CONCRETE
Stone and masonry are generally drilled in the impact
drilling mode.
When drilling in delicate materials such as wall tiles,
it is essential to start with ordinary drilling and, once the
tile is pierced, to continue with impact drilling.
In deep bore holes the drill bit should be pulled out
occasionally in order to remove the debris from the
drill and hole.
AUXILIARY HANDLE AND DEPTH GAUGE
See Figure 6.
Auxiliary handle
The auxiliary handle (8) can be rotated 360º.
Loosen the handle grip by turning in direction (15),
and tighten it at an easy to use position by turning
the grip in direction (14).
Depth gauge
Holes of a fixed depth can be accurately bored by using
the depth gauge (7).
The depth of the hole will be the distance from the end
of the bit to the end of the depth gauge.
By turning the handle grip in direction (14), the depth
gauge can be released and the depth adjusted. After
adjusting the depth, fix the depth gauge again by turning
the handle grip in direction (15).
LIVE TOOL INDICATOR
TM
This tool features a live tool indicator
TM
(11) which
illuminates as soon as the tool is connected to the power
supply. This warns the user that the tool is connected and
will operate when the switch is pressed.
MAINTENANCE
After use, check the tool to make sure that it is in good
condition. It is recommended that you take this tool to
a RYOBI Authorized Service Center for a thorough
cleaning and lubrication at least once a year.
DO NOT MAKE ANY ADJUSTMENTS WHILE
THE MOTOR IS IN MOTION. ALWAYS DISCONNECT
THE POWER CORD FROM THE POWER SUPPLY
BEFORE CHANGING REMOVABLE OR CONSUMABLE
PARTS (BLADE, BIT, ETC.), LUBRICATING OR
WORKING ON THE UNIT.
WARNING
To ensure safety and reliability, all repairs should
be performed by an AUTHORIZED SERVICE
CENTER or other QUALIFIED SERVICE
ORGANIZATION.
S AV E T H E S E I N S T R U C T I O N S F O R F U T U R E
REFERENCE.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
w a s t e . T h e m a c h i n e , a c c e s s o r i e s
a n d p a c k a g i n g s h o u l d b e s o r t e d f o r
environmental-friendly recycling.
SYMBOL
Safety Alert
V
Volts
Hz
Hertz
Alternating
Current
W
Watts
n
o
No load Speed
min
-1
Revolutions or reciprocations per minute
CE
Conformity
Double
Insulation
EID750RS__UM_EU_v1_emc_d1 Sec1:2
EID750RS__UM_EU_v1_emc_d1 Sec1:2
31/07/2012 12:34 PM
31/07/2012 12:34 PM
