![background image](http://html1.mh-extra.com/html/ryobi/csb1308/csb1308_operators-manual_1506406014.webp)
Page 14
51.5
45
30
45
0
15
OPERATION
LENGTH OF CUT SCALE
Fig. 19
BEVEL
ADJUSTMENT
KNOB
ADJUSTMENT
SCREW
POSITIVE 0˚
BEVEL STOP
HEX NUT
COMBINATION
SQUARE
SAW BLADE
Fig. 20
POSITIVE 0
°
BEVEL STOP
See Figure 19.
Your saw has a positive 0
°
bevel stop that has been factory
adjusted to assure 0
°
angle of your saw blade, when making
90
°
cuts. However, misalignment can occur during shipping.
TO CHECK:
■
Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental start-
ing causing possible serious personal injury.
■
Place your saw in an upside down position on workbench.
See Figure 19.
■
Using a combination square, check squareness of saw
blade to the base of your saw.
TO ADJUST:
■
Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental start-
ing causing possible serious personal injury.
■
Loosen bevel adjustment knob.
■
Loosen hex nut securing adjustment screw.
■
Turn screw and adjust base until square with saw blade.
■
Tighten hex nut and bevel adjustment knob securely.
WARNING:
Attempting to make cuts without bevel adjustment knob
securely tightened can result in serious injury.
LENGTH OF CUT SCALE
See Figure 20.
A length of cut scale has been provided on the base of your
saw. It is parrallel with the saw blade and can be used to
measure the distance into material the blade has cut.
NOTE: Six inches is the maximum length of the cut that can
be measured. Also, it is accurate only when the depth of cut
is set at full maximum depth.
Summary of Contents for CSB1308
Page 17: ...Page 17 NOTES...