![background image](http://html.mh-extra.com/html/ryobi/bts211/bts211_operators-manual_1506384037.webp)
37
ADJUSTMENTS
TO SET THE bLADE AT 0° AND 45°
See Figures 52 - 53.
The angle settings of the saw have been set at the factory
and, unless damaged in shipping, should not require set-
ting during assembly. After extensive use, they may need
to be checked.
Unplug the saw.
Raise the blade and the blade guard.
If the blade is not perfectly vertical (0°):
Loosen the adjustment bolt and the bevel locking lever.
Place a combination square beside the blade on the left.
Lock the angle by pushing the bevel locking lever down
and retighten the adjustment bolt.
Turn the bevel handle until the bevel indicator points to
zero. If the bevel handle is turned as far as possible and
doesn't indicate zero properly, you may need to adjust
the bevel indicator.
NOTE: It will be necessary to remove the bevel handle
to adjust the bevel indicator.
If the blade is not an exact 45°:
Loosen the adjustment bolt and the bevel locking lever.
Place a combination square beside the blade on the
left.
Turn the bevel handle until the bottom of the blade has
moved completely to the left side of the slot. Lock the
angle by pushing the bevel locking lever.
If the blade is not an exact 45°, loosen the 45° adjustment
bolt and the bevel locking lever.
Adjust the bevel indicator to 45°.
Make a test cut.
0° adJustment
Bolt
Blade
comBination
square
BeVel
indicator
BeVel
Handle
BeVel
locKinG
leVer
45°
Fig. 53
45° adJustment
Bolt
Blade
comBination
square
BeVel
indicator
BeVel
Handle
BeVel
locKinG
leVer
Fig. 52
Summary of Contents for BTS211
Page 41: ...41 NOTES ...