Ryobi BTS211, Operator'S Manual

Page: 16 / 42

16
ASSEMbLy
TO INSTALL THE HANDLE ASSEMbLy
See Figure 6.

Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle or the
washer from the end of the screw.

Place the nylon nut into the recessed hole on the back
of the height/bevel adjusting handwheel and hold in
place.
 Slide the handle, screw, and washer into the hole on the
height/bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
TO OPEN/CLOSE (SET-UP/TEAR DOwN) THE
LEG STAND
See Figure 7.
To open (set-up) the leg stand:

Step 1: With the saw table on end and standing to the side,
use your left hand to pull the leg stand latch towards you.

Step 2: Once the leg stand is released from the table saw
base, ease the legs of the stand down.

Step 3: Grasp the upper leg support below the saw cabi-
net.

Step 4: Keeping your left hand clear of the leg stand, pull
the leg stand up until it locks into place.

Step 5: With your left hand firmly on the table tilt handle,
grasp the leg stand with your right hand.

Steps 6 and 7: Push the leg stand towards the ground with
your right hand and pull in the same direction with your
left hand until the table saw is in an upright position.
To close (tear down) the leg stand:
 Steps 1 and 2: Standing to the side of the table saw, grasp
the table tilt handle with your left hand. Tilt the table saw
to your left and grab the leg.

Step 3: Lower the saw to the floor until it is balanced on
end.
 Step 4: Using your left hand, release the leg stand
latch.

Steps 5 and 6: Once the leg stand is released from the
table saw base, ease the legs of the leg stand toward
the floor.

Step 7: Lift the lower leg of the leg stand until it locks in
place.
Fig. 7
set-uP tear doWn