![background image](http://html.mh-extra.com/html/ryobi/airgrip-rlag113s/airgrip-rlag113s_operators-manual_1505029011.webp)
OPERATiON
ROUGH SURFACE AdAPTOR
See Figure 6.
Using the rough-surface adaptor, you can use
the laser level’s AIRgrip
™
feature to positon the
unit on many non-smooth surfaces, including
brick and painted cinderblock.
NOTE: The AIRgrip
™
feature cannot be used
with stucco or unpainted cinderblock.
Position the rough-surface adaptor on the
surface where you want to secure the laser
level.
NOTE: The dotted lines on the adaptor
should be visible.
Place the laser level against the adaptor
on the dotted lines, and push in slightly to
engage the seal.
Continue to hold the laser level against the
surface while pressing the on/off switch.
Release the laser level when you hear a
change in motor sound.
USiNG MULTi-FUNCTiON BASE
See Figure 7.
Velcro
®
strap, push pin, and tripod mounting
methods are available only when the multi-
function base is installed. To install the base:
While holding the laser level with the power
switch facing you, align the raised ridge on
the base with the groove on the level.
Slide the laser level and base completely
together.
NOTE: If the base is seated correctly, the
vacuum will not operate when the power
is turned on.
vELCRO
®
STRAP:
The strap can be used
to attach the laser level to irregularly shaped
Fig. 6