WARNING:
To reduce the risk of injury, user must read and understand the opera-
tor’s manual for their patio cleaner and this instruction sheet. Always
wear eye protection with side shields marked to comply with ANSI
Z87.1. Ensure compatibility and fit before using this accessory. Do not
use this accessory if a part is damaged or missing. If you are not com-
fortable performing any of the functions described in these instructions,
take your unit to a qualfied service center.
REPLACING THE BRUSH
See Figure 1.
Remove the battery pack.
Press the latch to release the brush and deflector assembly from the
unit.
Press and hold the spindle lock while carefully rotating the assembly
until the head locks securely into place.
NOTE:
Wear protective gloves while handling the brush.
Use the included hex key to loosen and remove the bolt.
Remove and dispose of the used brush.
Replace with the new brush.
Insert the bolt and finger tighten.
Press and hold the spindle lock and rotate the brush until the head is
locked.
Securely tighten the bolt.
Fig. 1
ACWB1 WIRE BRUSH
ACWB2 NYLON EDGING BRUSH
FOR USE WITH P2905 RYOBI PATIO CLEANER
A - Motor housing (boîtier du moteur, alojamiento del motor)
B - Latch (loquet, pestillo)
C - Spindle lock (verrouillage de broche, bloqueo del husillo)
D - Brush end cap assembly (ensemble de capuchon de brosse,
conjunto de tapa de extremo del cepillo)
E - Brush (brosse, escobilla)
F - Bolt (boulon, perno)
G - Hex key (clé hexagonale, lllave hexagonal)
A
F
G
C
D
E
B
