Ryobi 4000462550, Original Instructions Manual

Page: 25 / 32

TROUBLESHOOTING
Problem Possible causes Solution
Product refuses to
start
Product not plugged in Plug in product.
Defective socket Try another socket.
Defective extension cable Try without the extension cable.
Fluctuating pressure Pump sucking air Check that hoses and connections are air tight.
Valves dirty, worn out or stuck Bring the product to an authorized service centre for service
or repair.
Pump seals worn out Bring the product to an authorized service centre for service
or repair.
Product stops Fuse has blown Bring the product to an authorized service centre for service
or repair.
Incorrect mains voltage Check that the mains voltage corresponds to specification
on the model tag.
Thermal sensor activated Leave the cleaner for 15 minutes to cool down.
Nozzle partially blocked Clean the nozzle.
Product pulsating Air in inlet hose/pump Allow the product to run with open trigger until regular
working pressure resumes.
Inadequate supply of mains
water
Check that the water supply corresponds to the specifications
required (see model tag). Avoid using long, thin hoses.
Nozzle partially blocked Clean the nozzle.
Water filter blocked Clean the filter.
Hose kinked Straighten out hose.
Product often starts
and stops by itself
Pump/spray handle is leaking Bring the product to an authorized service centre for service
or repair.
Product starts, but
no water comes out
Pump/hoses or accessory frozen Wait for pump/hoses or accessory to thaw.
No water supply Connect the water inlet port to a water supply.
Water filter blocked Clean the filter.
Nozzle blocked Clean the nozzle.
No detergent Nozzle adjusted to high pressure Adjust to low pressure.
Tank is empty
Fill the tank.