9
OPERATING THE CLICK-LINK
®
SYSTEM -
MODELS 132r AND 137r
Models 132r and 137r are equipped with a Click-
Link System, which enables optional attachments
to be installed on this unit.
The optional attachments are:
Sweeper/Blower ........................................SB720r
Vacuum........................................................LV720r
Edger ..........................................................LE720r
Cultivator....................................................GC720r
Straight Shaft Trimmer ............ SS670r or SS725r
Tree Pruner..................................................TP720r
Snow Thrower ............................................ST720r
Hedge Trimmer ..........................................HS720r
Blower/Vacuum ..........................................BV720r
Blower ........................................................TB720r
Removing the Lower (Attachment) Boom
NOTE:
To make removing the boom easier,
place the unit on the ground or on a
table.
1. Loosen the knob
counterclockwise
(Fig. 12).
2. Push the release button
in
(Fig. 12).
3. Pull the lower boom straight out of the Click-
Link (Fig. 13).
CAUTION:
Make sure the release
button is locked in the primary hole
and knob is securely tightened
before operating this unit.
CAUTION:
All attachments are designed
to be used in the primary hole unless
otherwise indicated in the specific
attachment’s operator’s manual. If the
incorrect hole is used, it could result in
injury, or damage to the unit.
Click-Link
Click-Link
Release Button
Guide
Recess
Knob
Primary Hole
Upper
Boom
Lower
Boom
Release
Button
3. Tighten the knob securely
clockwise
before
using the unit (Fig. 14).
OPERATING INSTRUCTIONS
Fig. 11
OPERATING THE TWO-SPEED SWITCH -
MODELS 132r AND 137r ONLY
This unit is equipped with a two-speed switch -
a powerful high speed for demanding yard work,
and a precision low speed for light-duty yard
work.
Push the switch up for high speed trimming.
Push the switch down for low speed trimming
(Fig. 11).
Installing the Lower (Attachment) Boom
1. Remove the hanger from the lower
(attachment) boom. Hold the release button
down while pushing the lower (attachment)
boom into the Click-Link (Fig. 13).
2.
FOR BASIC TRIMMING OR USING OTHER
RYOBI ATTACHMENTS
- Locate and lock the
release button into the primary hole in the
Click-Link (Fig. 13).
Fig. 12
Fig. 13
Fig. 14
If your unit is not assembled, or you have
more than one attachment, use the following
instructions:
Trimming Head
Edging Hole (90˚)
Trimming
Head
Edging Hole
(180˚)
Knob
Washer
Summary of Contents for 105r, 132r, 137r
Page 15: ...15 NOTES...
