13
MAINTENANCE AND REPAIR INSTRUCTIONS
Fig. 28
Fig. 27
Fig. 26
Fig. 25
2. Remove the Bump Knob, foam seal, spring,
inner reel, and trimming line from the outer
spool (Fig. 25).
3. Remove any debris or grass from the knob,
spring, inner reel, and foam seal. Remove
any existing line from the inner reel before
cleaning. Wash the inner reel with warm
soapy water (Fig. 26).
NOTE:
The inner reel must be completely dry
before reinstalling it into the outer spool.
Do not lubricate the inner reel or outer
spool assembly.
4. Clean the shaft and the inner surface of the
outer spool. To clean the shaft underneath
the plunger, press down on the plunger
(Fig. 27). Remove any dirt and/or debris
from the shaft.
5. Install the inner reel, spring, foam seal, and
Bump Knob into the outer spool (Fig. 25).
6. Tighten the Bump Knob clockwise.
7. Install new line as described on pages
11 and 12.
INSTALLING A PREWOUND REEL
1. Insert the ends of the two trimming lines into
the eyelets in the outer spool (Fig. 28), then
grasp the ends and pull firmly to release the
line from the holding slots in the outer spool.
2. Hold the inner reel in place and install the
Bump Knob, spring and foam seal in the
counterclockwise direction. Line installation
is now complete.
Bump Knob
Foam Seal
Spring Assembly
Inner Reel
Inner Reel
Shaft
Summary of Contents for 105r, 132r, 137r
Page 15: ...15 NOTES...
