5
WARNING:
Never stand directly in line with the blade or allow hands
to come closer than 3 in. to the blade. Do not reach over
or across the blade. Failure to heed this warning can
result in serious personal injury.
+
-
INSTALLATION
Lower the blade below the table surface.
Loosen the screw and remove the throat plate.
Remove the blade and blade guard assembly following
instructions in the table saw Operator's Manual.
Included with the dado blade are installation instructions.
Follow these instructions to install the dado set.
Tighten arbor nut and blade washer securely.
Place dado insert on the table saw as shown in figure 1.
Securely tighten using screws provided.
WARNING:
Failure to turn the saw off, remove the switch key,
and unplug the saw could result in accidental starting
causing possible serious personal injury.
INSTALLING A DADO INSERT
USING A DADO INSERT
Make sure the wood is not touching the blade. Plug in the
saw, insert the switch key, and turn the saw on. Let the
saw build up to full speed before feeding the workpiece
into the blade. Always use pushsticks or pushblocks with
dado cuts.
See Figure 2.
WARNING:
Always use pushsticks or pushblocks when making non-
through cuts to avoid the risk of serious injury. Never
feed wood with your hands.
Follow all dado instructions.
When the work is complete, turn the saw off, remove the
switch key, and unplug the saw.
Lower the blade below the table surface.
WARNING:
Lower the blade to prevent possible injury.
Remove the dado insert and dado set or molding head.
Reinstall the blade, blade guard assembly, and throat plate
following instructions in the Operator's Manual.
WARNING:
To reduce the risk of injury and before plugging the
saw back in, make sure the blade guard is installed and
working properly.
TABLE TOP
DADO INSERT
SCREWS
Fig. 2
DADO CUT
PUSHSTICK
Fig. 1
