11
Before You Ride
OPERATING MODES
Your Micro-Cycle has three power states:
Power-off
WARNING
The Micro-Cycle can roll when it is powered off.
When you power off:
• Lean the Micro-Cycle forward on its parking bar.
• If parking on a slope of any kind, be sure and safely secure the Micro-Cycle to prevent it from rolling away.
• To show off the Micro-Cycle at home, place it in its parking stand.
Power-on/Standby State
To turn power on, turn the key switch, mounted to the left side of the hub cap, to the right. This will put the
Micro-Cycle in standby state where the processor is running and the lights are on.
Although the Micro-Cycle is powered on in standby, it is not rideable. If the Micro-Cycle is left parked in
standby (the key can be removed in this position) the Cycle will go to sleep in 60 seconds and the lights will
go off. Very little power is consumed in this state.
In Balance Mode (Ready to Ride)
Wait at least 2 seconds after turning the key for the software to load before putting it into Balance Mode. From
Standby-state, go to Balance Mode by holding both the silver power button next to the right handlebar grip and the
rear of the seat while you rock the bike forward and back slowly until you feel it snap into balance.
The Micro-Cycle is rideable in Balance Mode when the red light that surrounds the power button slowly blinks on
and off. Check the tail light blinking rate to see what speed mode you’re in.
****To take it out of balance, simply press the silver power button again.
WARNING
Do not sit on the bike when taking it out of balance, and be prepared to stabilize the bike as it switches out of balance mode.
Balance check
Before getting on the Micro-Cycle, put pressure on the handlebars to be sure that the Micro-Cycle is in balance. If the RYNO is in balance, it
will remain upright.
Speed Modes
The Micro-Cycle has two different speed limits. To change speeds, the cycle must be taken out of balance by
dismounting the cycle first and then holding the power button for three seconds.
While in standby mode the rider can toggle between these two speed modes by pressing both the attitude adjust
buttons at the same time. The speed mode will switch speed modes when the buttons are released. To check which
speed you’re in, look at the tail lights. Fast flashing is training mode, steady on is normal run mode.
1. Training mode is set to 5 MPH. The Cycle can easily be ridden at this speed during normal training. This mode
is indicated by fast flashing tail lights.
2. Normal mode is set to 10 MPH. This mode is indicated by steady on tail lights.
CAUTION
When making adjustments such as changing speed modes or raising or lowering the seat, be sure your Micro-Cycle is in either power-off or
standby mode. Do not make adjustments in balance mode.
