RYCO RYCS10 CUT-OFF SAW
5
8. INSTALLATION
Before installing and using the RYCS10 Cut-Off Saw, RYCO recommends thoroughly:
• Reading the contents of this operation manual
• Ensure all cords are new, intact, and suitable for the relevant power source; and,
• Inspecting the machine to ensure it displays:
–
2 x RYCO (logo) Labels
–
1 x RYCS10 (logo) Label
–
2 x Emergency Stop Labels
–
1 x Warning Label
–
1 x Hearing and Eye protection Label; and,
–
1 x Caution Label.
The RYCS10 Cut-Off Saw must:
• Be installed on a firm, stable, and level work surface with adequate clearance for safe working
• Be secured to the work surface using suitable M8 size bolts, washers, and nuts fastened through the mounting holes in the Cut-Off Saw
base as dimensioned in the figure below; and,
• Have clear, easy to access surroundings to allow operators to conduct any approved or suitable cleaning or maintenance.
Figure 3 – RYCS10 Mounting Holes
9.
COMMISSIONING
The RYCS10 Cut-Off Saw is shipped fully assembled and wired, ready for use.
After removing from its secure wooden box packaging, the RYCS10 Cut-Off Saw only requires mounting to the work surface, and
connection of the electrical plug to the appropriate mains power.
The RYCS10 Cut-Off Saw is intended for use in mobile service vehicles and/or workshop environments mounted to the work surface.
Prior to use, operators must check:
• All fasteners and the nut securing the Steel Cut-Off Blade to the shaft to ensure that it has not become loose in transit
• To ensure that no damage has occurred in transit
• The Steel Cut-Off Saw Blade is mounted centrally with no axial or radial run out, and that it rotates easily; and,
• Ensure that the direction of rotation is so that when viewed from the front Operating Handle side of the Cut-Off Saw, the Cut-Off Saw
Blade rotates in a direction from the top of saw to bottom of saw.
INSTALLATION AND COMMISSIONING
RYCO RYCS10 CUT-OFF SAW