
RYCO RYCS10 CUT-OFF SAW
8
EMERGENCY STOP BUTTON
5. Move the Operating Lever towards the hose ensuring that the hose is located against the Hose Support Pins
6. Ensure the hose is in the Support Notch at the bottom of the Operating Lever. The Blade Safety Guard moves with the Operating Lever
to expose the Blade to enable cutting to commence.
7. Continue to move the Operating Lever forward until the hose contacts the Steel Cut-Off Blade.
8. Maintain an even pushing force on the Operating Lever
NOTE:
Do not push too forcefully;
this may be indicated by the motor labouring or decreasing in RPM or stalling.
Excessive pushing force can damage the Steel Cut-Off Blade or cause the hose to become distorted/burnt. It may be necessary to pause
cutting for several seconds to allow the blade to cool sufficiently before continuing the cut.
9. When cutting is complete, release the Power ON/OFF Switch and move the Operating Lever to the fully back position.
10. Carefully remove the cut hose from the Saw Bed area.
11. Inspect the hose to ensure that the cut is clean and square at 90° to axis of hose.
Never leave the RYCS10 Cut-Off Saw machine powered on or running while unattended. To prevent any unintentional activation, ensure
the RYCS10 Cut-Off Saw is electrically isolated at the power source, and the EMERGENCY STOP button is depressed.
14. EMERGENCY STOP BUTTON
Should electrical power to the RYCS10 Cut-Off Saw motor need to be cut immediately in the
event of a dangerous/unsafe or emergency situation, the operator must press the Emergency
Stop button.
Emergency or unsafe situations can include (but are not limited to) overheating of work-piece or
saw components, the hose or any other item (i.e., clothing, body parts, jewellery, etc.) becoming
jammed or caught against the blade, or any other potentially unsafe circumstances as deemed by
the personnel using the equipment.
The Emergency Stop is located on the top of the RYCS10 Cut-Off Saw (see Figure 1 – Machine
Layout) and is identified by two red Emergency Stop labels (see Figure 2 – Danger Zones and
Warning Labels)
Once the Emergency Stop button has been pressed, all power to the RYCS10 Cut-Off Saw must be
disconnected by unplugging the machine from its power source (i.e., power socket).
15. SPECIFICATIONS
RYCS10 - SPECIFICATIONS
ELECTRICAL
PHYSICAL DIMENSIONS
PART NUMBER
VOLTAGE PHASE
MOTOR POWER
SPEED
WIDTH
DEPTH
HEIGHT
WEIGHT
kW
hp
RPM
mm
inch
mm
inch
mm
inch
kg
lb
RYCS10-1-240
240
1
1.5
2.0
2850
610
24.0
404
15.9
450
17.7
45
99
RYCS10 - TECHNICAL INFORMATION
NOMINAL CUTTING CAPACITY
PART NUMBER
BLADE SIZE
WIRE BRAID
SUCTION
4 SPIRAL
6 SPIRAL
MAX HOSE O.D.
mm
inch
Dash
inch
Dash
inch
Dash
inch
Dash
inch
mm
inch
RYCS10-1-240
250
10
-24
1.1/2
-24
1.1/2
-20
1.1/4
-20
1.1/4
55
2.1/8