ryan LAWNAIRE 28 544874F, Operator'S Manual

Page: 25 / 26

23
Lawnaire
28
SERVICE/SPECIFICATIONS
SPECIFICATIONS
Features:
Tricycle front wheel for easy maneuverability.
Rubber isolated handlebars and spring assist lift for
easy, comfortable operation.
Sealed precision ball bearings in tine arms and link-
age.
Engine:
Model 544874F
.............................B&S 12H332
Type 0144, Trim B8
4 cycle 6.5 H.P. Briggs & Stratton Vanguard
12.5 cu. in. (206 cc)
Model 544887 ...........................Honda GX200UTQX2
4 cycle 5.5 H.P. Honda GX Series
11.9 cu. in. (196 cc)
Starter.........................................Recoil, on/off switch
Governor....................................
3600 RPM, no load
Drive:
Primary....................................... V Belt / Roller chain
beveled gear differential
Tires:
Front........................................... 2.80 / 2.50 - 4
Rear............................................ 4.10 / 3.50 - 4
Dimensions:
Width.......................................... 41" (1041 mm)
Length......................................... 57" (1448
mm)
Width......................................... 34" (864 mm)
Weight........................................ 400 lbs.
(183 Kg)
Aeration:
Aerating Width........................... 28" (711 mm)
Tines.... Eight (8) 3/4" (19 mm) heat treated tines
on four (4) tine arms
Coring Depth..................... 2 1/2" (64 mm) max.
Coring Diameter..................... 3/4" (19 mm) max.
Coring Pattern.. 3 1/2" x 5" (89 x127mm)
Production........ up to 24,00 sq. ft./ hr (2230 M 2 / hr)
STORAGE INSTRUCTIONS
To prevent possible explosion or ignition of
vaporized fuel, do not store equipment with fuel
in tank or carburetor in enclosure with open flame
(for example, a furnace or water heater pilot
light).
Before the equipment is put in to storage for
any period exceeding 30 days, the following
steps should be taken.
1. Drain all fuel from the fuel tank and fuel lines.
2. Start the engine and run until all the fuel is used
from the carburetor float bowl.
3. While the engine is still warm, drain the
crankcase oil and replace with the proper weight
oil corresponding to the season the equipment
will next be used.
4. Remove the spark plug and squirt a small
amount of engine oil into the cylinder. Turn the
engine over a few times to distribute the oil.
5. Lubricate all lubrication fittings.
To put the equipment into service after an
extended period of storage:
1. Check for loose parts and tighten if necessary.
2. Check for cracked or broken tines and replace as
necessary.
3. Fill the fuel tank.
4. Check the engine and gear reduction case oil
levels with the engine in a level position.
5. Start the engine.
6. Check for fuel leaks.
7. Check clutch control operation to make sure the
unit stops when the clutch control is released.