HEAVY DUTY
SOD CUTTER
22
BLADE SHARPENING
1. Hand file bottom blade at 45
O
angle until no flat
remains.
2. To keep cutting edge less than 1/16" (1.5mm)
on 45
O
angle, grind milled surface back at 15
O
to
less than 1/16"(1.5mm).
3. Hand file side blades at 45
O
until no flat remains.
4. To keep cutting edge less than 1/16"(1.5mm) on
45
O
angle, grind milled surface back at 15
O
to
less than 1/16"(1.5mm).
THIS
1/16"
Maximum
45
O
15
O
FILE
DIRECTION
SURFACE
SMOOTH
(No Burrs)
BOTTOM BLADE
(1.5mm)
MILLED
EDGE
FILE
DIRECTION
1/16" MAX
THIS SURFACE SMOOTH
(No Burrs)
FILE
DIRECTION
SIDE BLADE
(1.5mm)
LUBRICATION CON'TD:
Gear Case:
The gear case is initially filled with 3 1/2 pints (1.7L)
of EP 140 Gear Lube. Do not add to this amount
unless the oil is changed or lost through leakage.
Gear case drain plug
D
.
Check gear case lubricant level by removing one of
the rear pitman bearing cap screws
E
. Add EP 140
gear lube through the pipe plug opening in the
gear case cover until oil comes out of the pitman cap
screw hole.
Drive Chain:
Oil every 25 hours.
MAINTENANCE / SERVICE
Summary of Contents for 544853G
Page 2: ......
