13
Fig. 5-6
Click
to adjust precooling temperature. When the set
precooling temperature is reached, the cooling stops and the system gives off
intermittent prompt tone to inform operators that the precooling is completed.
Click
/ [START/STOP] button to stop precooling early.
5.5 Placement of microcentrifuge tube
Vertically remove the rotor, loosen the rotor cover, put in the microcentrifuge
tube, restore the rotor to its original position vertically and tighten the rotor nuts
clockwise with rotor wrench until the rotor is firmly fastened (nuts must be tightened
firmly). Close the microcentrifuge lid.
Note: Don’t put your hands between the microcentrifuge and the lid when
opening and closing the microcentrifuge lid.
5.6 Centrifugation
5.6.1 Preset time/continuous run
Click any parameter block in the main interface including centrifugal force/speed,
temperature or duration to enter the following parameter setup interface.
