Rear View Safety, 1797 Atlantic Ave., Brooklyn NY 11233
800.764.1028 [email protected]
7
BEFORE BEGINNING INSTALLATION
Before drilling please check that no cable or wiring is on the other side of the
wall. Please clamp all wires securely to reduce the possibility of them being
damaged while vehicle is in use.
Keep all cables away from hot or moving parts and electrical noisy
components.
We recommend doing a benchmark test before installation to insure that all
components are working properly.
Step 1: Choose the monitor and camera locations.
Step 2: Install all cables in vehicle, when necessary a 0.8" (20mm) hole should
be drilled for passing camera cable through vehicles walls.
Install split grommets where applicable.
Step 3: Once all cables and wiring have been properly routed, perform a system
function test by temporarily connecting the system.
If the system seems to not be operating properly see troubleshooting (page 18).
