4
1)
Unplug the 12-volt power cord.
2)
Remove the claw from the brake pedal.
3)
Retract the air cylinder to the home position by lifting up the cylinder and sliding it
back so the claw legs are placed into the two holes of the RVibrake3 housing.
6)
Lastly, plug the Breakaway plug into RVibrake3. If the towed
vehicle becomes unattached from the motorhome,
BREAKAWAY will display on the Command Center tablet and
an audible alarm will sound. This means the Breakaway pin has
been pulled on the junction box, RVibrake3 will apply the
brakes on the towed vehicle, and it will be brought to a
complete stop. The Audio Assistant will let you know that
RVibrake is ready for towing.
Reference:
See the Breakaway Installation Guide for
installation and operation.
REMOVE RVibrake3
IMPORTANT
: Any time the towed vehicle’s engine is started after setup of RVibrake3,
the Auto Position process must be completed again to drain the vacuum in the
braking reservoir.
1) Unplug the 12-volt adapter.
2) Proceed to the above steps 4 and 5.
WARNING:
Tire damage or excessive brake wear will result
if the brake pedal is
manually depressed using your hand or foot during or after the Auto Position process.
The air cylinder will be improperly positioned causing the brake pedal to ride the
brakes. If this happens, the Auto Position process must be completed again for proper
setup.
1) Unplug the 12-volt adapter.
2) Proceed to the above steps 2 thru 5.
Summary of Contents for RVibrake3
Page 1: ...SETUP USER GUIDE...