Antenna Usage
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. FCC radiation Exposure Statement to comply with FCC RV exposure
requirements in section 1.1307, a minimum separation distance of 0.81 cm (0.3
inches) is required between the antenna and all persons. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
FCC ID:Z64-CC3100MODR1
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiver antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The Installer of this radio equipment must ensure that the antenna is located or
pointes such that it does not emit RV field in excess of Health Canada limits for the
general population; consult Safety Code 6, obtainable from Health Canada’s
website
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement
IMPORTANT
: Changes or modifications not expressly approved by Danko
Manufacturing LLC could void the user’s authority to operate the equipment.
COMPLIANCE
8
Summary of Contents for RVibrake3
Page 1: ...SETUP USER GUIDE...