RVE Merak E750 EVO, Instruction Manual

Page: 17 / 42

-16-
No.
1
2
3
4
5
6
Qty
Parts Description
零件名称
主轴
主轴定位环
杯头内六角螺丝M4x25
1
1
1
1
1
Step 3-5
主轴和主齿轮组装
主轴螺丝垫片
主轴固定螺丝M8x10 1
7
自锁螺母M4
内六角顶丝M3x3 2
Step 3-6
3-5 3-6 主轴和主齿轮组装
主轴定位环
自锁螺母M4
主轴螺丝垫片
主轴固定螺丝M8x10
杯头内六角螺丝M4x25
主轴
内六角顶丝M3x3
此处需要先把主齿轮和主轴用M4x25螺丝固定好，把M8x10
主轴固定螺丝也拧紧。在向上提拉主轴的同时下压主轴定
位环，最后在锁紧M3x3顶丝。上下提拉主轴无间隙即为安
装正确。
主齿轮安装好以后，需要调整尾传动大齿与小齿
的间隙；还需要调整主齿轮与电机齿的间隙。间
隙过小会带来较大的噪音和震动，还会加速齿轮
的磨损。间隙过大比较容易出现扫齿现象。建议
齿轮间隙为0.1-0.2MM之间。
2X
After the main gear is installed, it is necessary
to adjust the main gear and the tail drive gear
for clearance. The gap between the main gear
and the motor pinion gear also needs to be
adjusted. The gap too small will bring greater
noise and vibration, and will accelerate the
wear of gears. If the gap is too large, the
phenomenon of tooth sweeping is more likely
to occur. The recommended gear clearance is
between 0.1-0.2MM.
Here you need to use M4x25 screws for the main gear
and the main shaft After fixing it, tighten the M8x10
screw.Then pull up the main shaft while the main shaft
stopper moves downwards press, and finally tighten the
M3x3 set screws. Check if there is axial play on the
mainshaft by moving up and down. If so remove play.
/ Main gear and main shaft Assembly
Main Gear and main shaft assembly
Main Shaft
Mast Stopper
Mast Washer
Mast Bolt M8x10
Nylon Nut M4
Set Screw M3x3
Socket Screw M4x25
Main Shaft
Mast Stopper
Mast Washer
Mast Bolt M8x10
Socket Screw M4x25
Nylon Nut M4
Set Screw M3x3