INSTALLATION AND SETUP
RUSTIBUS® 32 ELECTRIC 220V
Before you begin.
Step 1: VERIFY THE COMPLETENESS OF YOUR RUSTIBUS® 32.
•
Check that all components are attached properly and in a proper / safe working order.
(Check that there are no loose guards or parts on the machine)
Step 2: ASSOCIATED EQUIPMENT.
•
Ensure that you have the required power source available. This electric
Rustibus®
32 machine can only
be connected to an
AC Single Phase 220-240V (50/60Hz) outlet!
It is also possible to connect the
machine to sockets without earth contact as it is designed according to safety class II.
•
Ensure that you have available necessary length of power lead to use with the machine.
•
If working outdoors it is recommended that you connect the
Rustibus®
32 using power
leads intended for use in that area.
Step 3: BEFORE COMMENCING THE OPERATION.
•
Locate the section to be cleaned / de-scaled and determine if the area needs to be cleaned. Excessive
grease, dirt and other hazardous material should be cleaned from the surface area before
operation of the
Rustibus®
machine.
•
Ensure Chain Drum is properly connected to motor
•
The Chain drum rotates at high RPM, show utmost care when connecting power lead and when
operating machine.
ALWAYS THINK SAFETY FIRST!
•
Connect your machine to its power source.
•
Make sure the power lead is properly connected and safely located for your operation.
•
Start and Stop the machine and check that rotation is correct according to marking on machine.
Step 4: OPERATION OF RUSTIBUS MACHINE.
•
For the best results from your
Rustibus®
machine you should run the machine forward and backward
over the area until the appropriate result is achieved
• Do not run the machine over sharp edges, but along them. Your machine will last longer if operated
with care.
•
DO NOT FORCE YOUR MACHINE DOWNWARDS!
This does not improve the result, it only damages the
machine.
•
The
Rustibus®
32 is equipped with a dead-man switch to ensure operator safety. Note that the machine
will not be idle immediately. Allow the machine to come to a stop before putting down.
Step 5: MAINTENANCE OF RUSTIBUS MACHINE.
•
ALWAYS stop the machine and disconnect it from its power source before carrying out any maintenance
on the machine.
•
To maintain your
Rustibus®
32V in a good working order, the machine and motor should be
cleaned after use. The ventilation slots of the motor must be kept clear at all times.
When the machine is
due for storage, please clean and check the machine for damage or wear and tear.
Genuine Rustibus® parts only!
Machine may vary from pictures
