RUSTA 902012350101, Manual

Page: 3 / 24

3
BEFORE USING YOUR WATER KETTLE
If you are using the kettle for the first time, it is recommended that you should clean
it before first use by boiling the Max capacity of water once and then discarding the
water. Wipe the surface with damp cloth.
NOTE: The max capacity of kettle is 1.5 L
and the effect is 1500 W.
USING YOUR WATER KETTLE
1. Place the unit on a level surface.
2. To fill the kettle, remove it from the base and open the lid by pressing the lid
release button, fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should
not exceed MAX marks or sit below MIN level. Too little water will cause the
kettle to swtich off before the water has boiled.
NOTE: Do not fill the water over
the maximum level, as water may spill out of the spout when boiling. Ensure
that the lid is firmly in place before plugging in the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/Off switch, the
indicator will light up. The kettle will start to boil the water. Once the water
has been boiled, the On/Off switch will turn off automatically. You can shut the
power off by lifting the On/Off switch at any moment during the boiling cycle.
If you want to boil water again, just press down the On/Off switch directly
to restart the boiling cycle.
NOTE: Ensure that the On/Off switch is free of
obstructions and that the lid is firmly closed, the kettle will not turn off if the
switch is constrained or if the lid is open.
5. Lift the kettle from the power base and pour your water out. NOTE: Operate
carefully when pouring the water from your kettle as boiling water may result in
injury. Never open the lid completely while the water in the kettle is hot.
NOTE: Always disconnect the power supply when not use.