RUSTA 308015570101, Manual

Page: 13 / 60

13
MENU SELECTION
Use MODE button to choose different modes (VIDEO, PICTURE, PLAYBACK)
Use MENU button to open menu and to switch between different menus
Use UP and DOWN buttons to select and OK button to confirm
IN VIDEO MODE
RESOLUTION
Chose video recording resolution - VGA 640x480, WYGA 848x480, 720P 1280x720,
1080P 1440x1080, 1080FHD 1920x1080
LOOP RECORDING
To set videos looping time - 1 min,2 min,3 min, 5 min, Off
EXPOSURE
Adjust if video recording should be over or under exposed depending on light situation -
+0.0, -1/3, -2/3, -1,0, -4/3, -5/3, -2.0, +1/3, +2/3, +1.0, + 4/3, +5/3, +2.0
MOTION DETECTION
When turned ON the camera will detect motion and record automatically in stand by
mode – On, Off
DATE STAMP
To watermark video with date – On, Off
RECORD AUDIO
To turn On/Off audio recording – On, Off
G-SENSOR
When the G-sensor is turned on and there is a collision, the video being recorded will be
protected and not possible to overwritte. The G-sensor can be set to different force of
impact – Off, 2G low sensitivity, 4G middle sensitivity, 8G high sensitivity
PARK MODE
When the car is parked and camera is off, and there is a collision, the camera will turn
on automatically and record for approx.. 20 seconds. Then it will turn off again. If new
collision it will start again do new recording 20 sec. The battery has capacity to record
approx. 10 times at the most without new charging
DATE / TIME
To set the date and time used for Date stamping and showing on display. Select Date /
Time and press OK key to set date/time. Press UP key / DOWN key to adjust the num-
bers then press OK button to confirm. Press MODE button to move the light bar to next
choice. Finally press OK key to exit date/Time setting to the upper menu
AUTO POWER OFF
Set time before automatically turning off – Off, 1min, 3min