26
ST2-XM Tuner Setup Menus
Note:
The Setup Menu procedures must be performed from the ST2-XM Tuner front panel.
The ST2-XM Tuner Setup Menus provide setup and naming procedures for the ST2-XM main chassis,
the XM tuner module and the AM/FM tuner module. These procedures include source number assign-
ments, assigning a custom name to a memory preset or a bank, choosing a region for AM/FM opera-
tion (US or Euro), factory initialization and system information.
If the ST2-XM is used with a
non-RNET
system, the ST2-XM can be connected and operated without
any setup programming. Follow the setup menus if custom names are desired, or for system info.
If the ST2-XM is used with an
RNET system
such as
CAV6.6
, the following minimum setup must be
performed for the ST2-XM to be properly controlled by the CAV6.6.
1. ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.
2. CAV6.6 Source Setup Menu - Assign the corresponding source numbers to Tuner 1 and Tuner 2.
3. CAV6.6 Source Setup Menu - Assign command type PERIPHERAL to Tuner 1 and Tuner 2.
NOTE:
Once the programming procedures are completed, cycle power first to the Tuner and then
to the CAV6.6 (must be powered on last) to establish a connection.
ST2 Chassis Setup Menu
Source Number (Chassis)
The Source Number procedure permits Tuner 1
(XM) and Tuner 2 (AM/FM) to be assigned the
proper peripheral source identities as will be
assigned in the CAV6.6 Source Setup.
1.
Enter the Setup Menu by pressing and holding
the TNR SEL button.
2.
TUNER SETUP appears. Press MEM Up/Down
until SOURCE NUM appears on the tuner.
3.
Press BAND. TUNER # appears.
4.
Press the Tune Up/Down buttons to select the
Tuner # (Tuner 1 is XM, Tuner 2 is AM/FM).
5.
Press BAND. SOURCE NUM appears.
6.
Press the Tune Up/Down buttons to scroll
through the source numbers 1-6.
7.
Press BAND to select the source number (as
assigned in the CAV6.6 setup process).
8.
Repeat the process for the next tuner.
9.
Press TNR SEL to exit the Source Number
menu.
Update Firmware (Chassis)
The Update Firmware procedure allows the ST2
tuner’s OS firmware to be updated. The proce-
dure is performed using a DB9 serial cable with
one end connected to the RS-232 port on the
back of the tuner and the other connected to a
PC or laptop. If an OS firmware update is avail-
able, it can be obtained through the Document
Center at
www.russound.com. XM tuner module
firmware must be performed by an authorized
Russound service facility.
1.
Enter the Setup Menu by pressing and holding
the TNR SEL button.
2.
TUNER SETUP appears. Press MEM Up/Down
until UPDATE FIRMW appears on the tuner.
3.
Press BAND to enter the UPDATE FIRMW menu.
ST2-XM TUNER PROGRAMMING
ST2 TUNER SETUP MENU