8
Russound Acclaim Speakers Installation Manual
INSTALLATION
Installation
1. Connect the speaker wire to the speaker terminals:
• Leave about 2' (60 cm) of wire extending through the ceiling cutout.
• Pull the conductors apart so the last two inches are separated and
remove 1/2" (13 mm) of insulation from the end of each conductor.
• Twist the strands in each conductor into tight spirals.
• Attach the speaker wires to the red and black speaker terminals. Connect
the Positive (+) conductor to the Red terminal and the Negative (-)
conductor to the Black terminal. Make sure that no stray strands of wire
are touching the other conductor or terminal.
• Single point speakers have four terminals; Right(+), (-) and Left(+),
(-). Run an extra pair of conductors and observe proper polarity when
making connections.
Insertion of speaker wire on back of speaker baffle
2. Center the speaker in the cutout. Rotate the frame as needed before
tightening the screws. Tighten the screws equally until the clamps secure
the frame. Do not overtighten.
3. Attach the magnetic grille.
Speaker
As screws are tightened
clamp will rotate out and
snug against the drywall.
Cutout
Screws
Speaker Cable
Install Speaker
(+)
(+)
(-)
(-)
Models:
RSF-635
RSA-635
RSA-835
Models:
RSF-610
RSF-620
RSF-610T
RSF-820
RSA-615
