4
Installing the AirPort Express
®
into the AirGo Outdoor
1.
Remove the detachable electrical prongs from the
AirPort Express by sliding the Power Adapter off of the
AirPort Express. See
Figure 3
2.
Take the 3.5mm audio plug located in the APX
Pocket and insert it into the Audio Output Jack of the
AirPort Express. See
Figures 4 & 5
3.
Take the power cord from the APX Pocket and insert
it into the Power Input jack of the AirPort Express.
See
Figure 5
4.
Carefully place the AirPort Express and all of the
connected wires into the APX Pocket.
NOTE:
Make sure the APX cover is seated securely
in place and fastened tightly in place by the philips
screws to ensure a proper seal of the compartment.
5.
Place the cover back onto the APX Pocket and
tighten the screws until they are snug.
6.
Plug the Main Power Cord into a grounded
electrical outlet. Turn the Power Switch ON and wait for
the AirPort Express to boot up.
NOTE:
The status of the AirPort Express and its booting
process can be observed at the Status Light window
located on the AirPort Express Pocket Cover.
See
Figure 2
NOTE 2:
Never plug the AirGo Outdoor into an
ungrounded electrical outlet, ungrounded electrical
cord or use a ground lifting adapter to remove the
safety ground.
Power Adapter
Audio output Jack
INSTALLATION
Figure 3
Figure 4