5
Assembly Instructions
The fan has been packaged unassembled to minimise packaging waste.
Each part is designed to fit together and be disassembled easily for cleaning or storage. To
assemble you will need a screw driver and the supplied Allen key.
Start with the tripod leg assembly as follows:
Using the Allen key, unscrew all three grub screws from the leg/post coupling until they are
sticking out approximately 4mm from the top of the nuts as shown below.
Whilst holding the leg / post coupling upside down, take a wooden leg and insert the flat end
into one of the leg tubes and push down all the way as shown below. Using the Allen key,
tighten the grub screw until it is firm and holding the wooden leg in place
Repeat the steps above for the remaining two legs and then rotate the tripod over and
stand on its three legs.
Loosen the post securing knob by turning it anti-clockwise and remove it.