Russell Hobbs RHDH1001, Manual, Page: 9 / 24

Continuous Dehumifier (Extraction) Mode
•
For maximum extraction rate, the Continuous Dehumidifier
(Extraction) mode should be used.
•
Press the Continuous Dehumidifier (Extraction) button on the
control panel. The Continuous Dehumidifier indicator light will
illuminate when this mode is selected.
•
The unit will continue to run at the maximum extraction rate until
the water tank reaches the max fill level.
•
Press the Continuous Extraction button again to cancel the
continuous extraction.
Note: The humidity cannot be set when the unit is operating in
Continuous Dehumidifier (Extraction) Mode
Setting the Humidity
•
The desired humidity level can be set within a range of 35% to 85%
Relative Humidity in 5% increments / decrements by pressing the
+ and
– keys.
•
To select the desired humidity level ensure the unit is not on the
continuous mode. This can be done by checking the CONT.
indicator is not illuminated. If it is then simply press the CONT
button to de-activate the continuous mode and the CONT.
indicator will switch off.
•
Use the Up and Down control buttons to select the desired
humidity. The display will flash while the humidity is being set.
•
For drier air, press the pad and set to a lower percent value(%).
•
For damper air, press the pad and set a higher percent value(%).
Note: The humidity cannot be set when the unit is operating in
Continuous Dehumidifier (Extraction) Mode
USING YOUR DEHUMIDIFIER
Page 9