16
Rinse Aid Dispenser
The rinse aid dispenser has 5 settings.
Please follow the steps below for adjustment in rinse aid level:
1. Open the door and switch on the appliance.
2.
Within 60 seconds after the appliance was switched on press and hold the ‘Program’ button
for more than 5 seconds and then press the ‘Delay’ button to start the rinse aid setting
function. The rinse aid warning light will flash periodically during the setting function. The
unit will exit the salt setting function if no button is pressed within 5 seconds.
3.
Press the ‘Program’ button to select the required rinse aid level in accordance with usage
habit. The program indicator lights will light up to indicator the different rinse aid levels
(please see the table on the following page). The rinse aid levels will change in the following
sequence: D1->D2->D3->D4->D5 (D1 is the lowest setting and D5 is the highest setting). The
default setting is D3 but increase if performance is not as required
4. Press the On/off button to set the softener level.
Note: Increase the rinse aid level if there are drops of water or lime spots on the dishes after
washing. Reduce it if there are sticky whitish stains on your dishes or a bluish film on
glassware or knife blades.
Detergent
Detergent with its chemical ingredients are necessary to remove dirt, crush dirt and transport it
out of the dishwasher.
Important notes:
•
Only use detergent specifically made for use in dishwashers.
•
Keep your detergent fresh and dry.
•
Don't put powder detergent into the dispenser until you're ready to wash dishes.
•
Dishwasher detergent is corrosive! Keep it out of reach of children.
Rinse aid level
Program indicator
light sequence
D1
Rapid 30'
D2
Quick 90'
D3
Quick 90' & Rapid 30'
D4
Glass
D5
Glass & Rapid 30'
