MAINTENANCE OF FILTER
S/N
Filter
Replacement Cycle
Filter Maintenance
1
PP cotton
6~12 months
When the PP cotton surface is dirty
please remove and clean the PP
cotton cover. It is suggested to flush it
from the rear side under the faucet; it
should be cleaned at least once a
month.
2
Active
carbon
6~12 months
It must be flushed with water for over
5min before using it for the first time,
install the ultra-filtration filter after it
isn
’t outputting black water.
3
Ultra-
filtration
6~12 months
When the ultra-filtration filter outputs
water at a lot flow rate (<60ml/min),
please remove and clean the ultra-
filtration filter. It is suggested to flush
it under the tap, carefully swing it
when flushing, and avoid flushing it
with rapid water. It shall be cleaned at
least once a month.
NOTE:
The replacement cycle is subject to the local water quality in your area
REPLACING THE FILTER
1. Open the upper cover of the active carbon filter, take out the active carbon, flush the filter
housing, then add active carbon according to Step 2 mentioned above
2. Open the ultrafiltration filter, take out the ultrafiltration, replace it with a new ultrafiltration,
the method is shown as below
:
1). Filter housing, seal ring and filter.
2). Fix the seal ring on the filter.
3). Insert the filter and seal ring into the upper housing.
4). Rotate and align the upper and lower housing.
