Russell Hobbs 19006, Instructions Manual

Page: 5 / 12

5
17 Align the pips on the cap with the slots in the hole, fit the cap in
the hole, and turn clockwise.
,
Don’t run the blender without the cap.
18 To add ingredients while the motor is running:
a) turn the cap clockwise to unlock it, and lift it off
b) add the ingredients via the hole
c) replace the cap, and turn it anti-clockwise to lock it
19 Turn the jug anti-clockwise to unlock, and lift it off the motor unit.
N CRUSHING ICE
20 Start with half to threequarters of a cup of ice, or 4 to 6 cubes,
and add 15ml (1 tbsp) of water.
21 Put the lid on the blender, then turn the speed control to
Y
for a
second or so, check the state of the ice, and repeat till the ice is
the consistency that you need
N CARE AND MAINTENANCE
22 Switch off (0) and unplug before cleaning.
23 Wipe the outside of the motor unit with a clean damp cloth.
24 Handwash the removable parts.
`
You may wash these parts in a dishwasher.
25 If you use a dishwasher, the harsh environment inside the
dishwasher will affect the surface finishes.
26 The damage should be cosmetic only, and should not affect the
operation of the appliance.
N BLADE UNIT
27 You may remove the blade unit for cleaning.
28 This is best done with the jug upside down.
29 Grip the jug handle with one hand.
30 Grip the bottom of the blade unit with the other hand.
31 Turn the blade unit clockwise till it comes loose from the jug base.
32 Carefully, pull it up and out of the bottom of the jug.
33 Wash the seal and blade unit in warm soapy water, rinse, and air
dry.
34 Take great care with the blades – don’t handle them directly, use
a nylon washing-up brush.
35 Replace the seal round the blade unit.