You should be ready to connect your controller (VISCA or DMX) and
begin operating the PTX and BABYZOOMER kit!
Connect the power cord to the base of the
PTX, and the unit will start initializing the
pan and tilt axes. If the kit is too far forward
or backward to allow proper tilt initialization,
the initialization will simply fail, like you see
here.
If so, disconnect the PTX power cord …
then loosen the thumb screws and slide the
kit slightly toward the rear or front as
necessary. Re-tighten the thumbscrews …
then connect the power cord again. Once
the unit successfully initializes you should
be optimally balanced for normal operation.
Loosen the thumbscrews holding the
BABYZOOMER assembly to the PTX and
slide it backward or forward to make sure
it is well balanced, then tighten the
thumbscrews to lock it into place.
Failed initialization results in the camera falling
forward or backward during power-up.
